For a millwright with proper tools to put a seal kit and bearings on this garberator Waste King model-20003
Five hours and thirty-seven minutes...plus or minus a few hours.
That's me being facetious. Your question is relative, so it can't be answered as you'd like it to be.
As a field tech, I (and my company) quit rebuilding garbage disposals because...well - we charged by the hour. There was no standard rate. As such, there were too many times when our final cost to a customer was too costly to justify doing it AGAIN - when all we would warranty AFTER the repair was the industry standard 30 days labor/90 days parts. Oftentimes the price pushed 75% of the cost of a new unit.
If you decide to do this, then understand that it is NOT easy. The biggest challenge is removing the stationary shredder (Waste King calls the "grind ring"). It's pressed in. Sometimes - rust and crud assured its place in there TOO well. SO, there's no telling how difficult it might be to remove.
I've popped a few of those out in a matter of minutes...and then had some which took me HOURS of frustration...and MANY applications of heat from a torch to remove.
I've never worked on a Waste King. However, for all the others I repaired (In-Sink-Erator, Salvajor, Red Goat and others), the stationary shredder must come out in order to remove the rotating shredder (Waste King calls the "turntable assembly").
Here's you a parts manual:
I have to agree with ectofix. on this one. It's not the seal that's the problem, but the unknowns that you will run into after removal and dissassembly. Like corrosion in the housing where the seal has to seat, or damaged and worn out blades, or disturtion to the grinder ring from corrosion and removal. And lets not forget that at some point the motor bearings got a bit of moisture and are rough. Unless its more than 2 HP and stainless, buy a new one.
Retrieving data ...