we have a 4432-n 12m we cannot get the door to stay closed. We have tightened the hinges. if they need replaced which parts do we need?
Is the unit level? That could make the doors pop open. Even if the unit is slightly tilted (a couple degrees) to the rear, that will really help the doors stay closed. Very often, these doors are slammed shut by workers and they just pop right back open.
Otherwise, here's the hinge kit
Delfield RF000066-S KIT HINGE 6000 FULL DR NEW | Parts Town
How loose were the hinges (since you said you tightened them). This could have irreparably damaged the hinges, door, or frame. If the frame is damaged, you will need a service agent to come in and repair that kind of damage.
Forgot to ask: what kind of shape is the gasket in? A bad gasket can cause the door to seal poorly and open back up.
The bottom hindge has a spring in it, but has to be installed with the tension correct. It has a square pin that has to be indexed in the square hole.
Also the door gaskets are magnetic. Make sure the munion is clean and the gasket is intact, and not bunched up. Check that the heel of the door is not set to close to the box, as this makes the gasket twist and push out instead of pulling in.
Retrieving data ...