3liter brewer stops brewing after only about 30 sec. and shows the “insert brew basket” code. All parts are in place. What senses the brew basket? What else should I be looking at? Thank you.
The controller is showing an "HA" alarm on my Perlick unit? it seems to be laughing at me... -Bob
have two new Pitco 40D fryers on a concession trailer. One fryer i was able to get started. I had it set for 350 degrees and after about 30 minutes it shut off and I couldn’t get it started again. The pilot would light but no matter how long I held the pilot switch in for it would go out when I released it. The second fryer I was able to get the… Show more
★ 06/07/2019--wp--checked unit pilot lit but valve wouldn©t open looked at t stat and terminal #2 left was pulled out. removed wires and touched together burner came on. went to remove 5/16 nut from cap tube and it stripped was too! tight. had to cut cap tube off to get socket on 9/16th nut because it was too tight and started to strip. got old t…
Hey Guys, So I am running into an issue with my 3 bin deep fryer, model is: FM3CFESC and serial is: 0911HJ0011,10,09 for all 3 bins. 2 of the 3 are intermittently dying while running, the main flame will be on and it will suddenly just turn off along with the pilot (if I remember correctly). I know there is a thermopile for the pilot but… Show more
have a few TurboChef NGC ovens.I have a problem with grease getting into the all the components.Im not sure as to why this is, some are from 2006 or 2009. I started replacing the catalytic converter thinking this will help. has anyone been doing this and if so , how long does it need to be done
There is no air door seal like on all of the newer models. If you are passing the leak check then is should be ok. The one thing you said that bothers me though. You can not clean the guides. They must be replaced. Why? When the wave travels down the guide it needs to reflect and not be absorbed. As soon as it absorbs then it will cook the guide…