Log in to follow, share, and participate in this community. Not a member? Join Now! the rest of the system will start. the compressor starts if I push in the contactor. no codes from the control board. the leds are working as they should have replaced a bad start relay. check all switches. unit is ch... Can’t seem to find a diagram. I have a Manitowoc SD0502A ice machine. It stopped producing Ice and after inspection of the machine I discovered that the silver round capacitor below the control board was bulging. I replaced the capacito... hi. i have a MIM452 and when i go to turn it on it makes the first batch of ice then stops. thats when the green light starts to flash. i hit the mode button to make ice again and it starts working. it only does one b... What controlling thermostat can i put in star-mite deep fryer model 2T-Y2292 Over the past couple of weeks I have been blocked from logging onto the website, I have received updated password links from yourselves and I have inputted the relevant information and occasionally the login will work... I did notice the rubber seal looked a little old and some grease had passed through but even after cleaning that well it has still turned the liquid content gray after being frozen awhile. What to convert my fryer from natural gas to Lp Gas The idle speed is too high . throttle solenoid goes in if I push with my finger only. I need a new solenoid I think there's a dead spot on the idle. Just need to do a self repair. Thanks I need a overload and relay for a turbo air M3R24-1 hello looking for a part to hobart oven M# CN-90 Hobart # 00347063-00001 Trying to troubleshoot why a thermostat is NOT turning off or controlling temperature in a TM-52F True Freezer. I've replaced the t-stat and it still does not control. Freezer runs continuously and drives ... I know this is a probe failure . wondering if init will operate and defrost under this condition ? I have turbo chef toasting oven model#ngc ,208 or 230-240 vacation 30 amp so what size breaker should I install (30 amp or little higher ) I replaced the Thermostat and heater core and the water does not get hot!